Table of Contents
Advertisement
2. Put the detergent, in powder or tablets, in the
compartment (A).
3. If the programme has a prewash phase, put a
small quantity of detergent on the inner part of
the appliance door.
4. Close the lid. Make sure that the release button
locks into position.
SETTING AND STARTING A PROGRAMME
Starting a programme
1. Keep the appliance door ajar.
2. Press the on/off button to activate the
appliance. Make sure that the appliance is in
programme selection mode.
3. Press the programme button repeatedly until
the indicator of the programme you want to
select starts flashing.
4. Close the appliance door to start the
programme.
Starting a programme with delay start
1. Set a programme.
2. Press Delay Start to delay the start of the
programme of 3 hours.
•
The indicator
3. Close the appliance door to start the
countdown.
When the countdown is completed, the programme
starts.
Opening the door while the appliance
operates
Opening the door while a programme is running
stops the appliance. It may affect the energy
consumption and the programme duration. After
closing the door, the appliance continues from the
point of interruption.
If the door is opened for more than 30
seconds during the drying phase, the
running programme ends. It does not
happen if the door is opened by AirDry
function.
HINTS AND TIPS
GENERAL
Follow the hints below to ensure optimal cleaning
and drying results in daily use and to protect the
environment.
•
Washing dishes in the dishwasher as instructed
in the user manual usually consumes less water
and energy than washing dishes by hand.
12
comes on.
Do not try to close the appliance door
within 2 minutes after AirDry
automatically opens it, as this may
cause damage to the appliance.
If, afterwards, the door is closed for
another 3 minutes, the running
programme ends.
Cancelling the delay start
Press the on/off button for 3 seconds until the
appliance is in programme selection mode.
When you cancel the delay start, you have to set
the programme again.
Cancelling the programme
Press and hold the programme button for 3
seconds until the appliance is in programme
selection mode.
Make sure that there is detergent in the detergent
dispenser before you start a new programme.
The Auto Off function
This function decreases energy consumption by
deactivating automatically the appliance when it is
not operating.
The function comes into operation:
•
When the programme is complete.
•
After 5 minutes if a programme was not started.
End of the programme
When the programme is complete, the programme
indicator remains on until the Auto Off function
switches the appliance off.
If the acoustic signal for the end of a programme is
activated and the programme is complete, the
appliance is automatically switched off after the
signal sounds.
1. Press any button to switch off the appliance or
wait for the appliance to switch off
automatically. If you close or open the door
before automatic deactivation, the appliance is
deactivated.
2. Close the water tap.
•
Load the dishwasher to its full capacity to save
water and energy. For best cleaning results,
arrange items in the baskets as instructed in the
user manual and do not overload the baskets.
•
Do not pre-rinse dishes by hand. It increases
the water and energy consumption. When
needed, select a programme with a prewash
phase.
Advertisement
Table of Contents
