Using The Detergent; Setting And Starting A Programme - Zanussi ZDSN151X2 User Manual

USING THE DETERGENT

A B
CAUTION! Only use detergent
specifically designed for dishwashers.
1. Press the release button (B) to open the lid (C).
2. Put the detergent, in powder or tablets, in the
compartment (A).
3. If the programme has a prewash phase, put a
small quantity of detergent on the inner part of
the appliance door.
4. Close the lid. Make sure that the release button
locks into position.
For information about the detergent
dosage, refer to the manufacturer's
instructions on the packaging of the
product. Usually, 20 - 25 ml of gel
detergent is adequate for washing a
load with normal soil.
Do not fill the compartment (A) with
more than 30 ml of gel detergent.

SETTING AND STARTING A PROGRAMME

Starting a programme
1. Open the water tap.
2. Close the appliance door.
3. Turn the knob until the programme marker is
aligned with the programme you want to set.
• The on/off indicator is on.
• The start indicator starts to flash.
4. Press .
• The programme starts.
• The indicator of the washing phase is on.
• The on/off indicator and start indicator are
on.
Starting a programme with delay start
1. Set a programme.
12
30
20
C
2. Press to delay the start of the programme
by 3 hours.
The light related to the button is on.
3. Press to start the countdown.
The light related to the button is on.
During the countdown, it is not possible to change
the programme.
When the countdown is complete, the programme
starts.
Cancelling the programme
Press and hold until the light related to the
button starts to flash.
Make sure that there is detergent in the detergent
dispenser before you start a new programme.
Cancelling the delay start while the
countdown operates
1. Press and hold
the button starts to flash.
2. Press to start the programme.
Opening the door while the appliance
operates
Opening the door while a programme is running
stops the appliance. It may affect the energy
consumption and the programme duration. After
closing the door, the appliance continues from the
point of interruption.
If the door is opened for more than 30
seconds during the drying phase, the
running programme ends. It does not
happen if the door is opened by AirDry
function.
Do not try to close the appliance door
within 2 minutes after AirDry
automatically opens it as this may
cause damage to the appliance.
If, afterwards, the door is closed for at
least 3 minutes, the running
programme ends.
The Auto Off function
This function decreases energy consumption by
deactivating automatically the appliance when it is
not operating.
The function comes into operation:
• When the programme is complete.
• After 5 minutes if a programme was not started.
until the light related to