Installation of Indoor
Installation of Decoration Panel
The decoration panel has its installa-
tion direction.
1. Temporarily fix two decoration panel fixing screws (hexagon M5 screw) on the unit body. (Tighten by
amount 10mm(3/8 inch) in length.
The fixing screws (hexagon M5 screw) are included the indoor unit box.
2. Remove the air inlet grille from the decoration panel. (Remove the hook for the air inlet grille cord.)
3. Hook the decoration panel key hole (
that the screws reach the key hole edge.
4. Retighten completely two temporarily fixed screws and other two screws. (Total 4 screws)
5. Connect the louver motor connector and display connector.
6. After tightening these screws, install the air inlet grille (including the air filter).
Air conditioner unit
Decoration panel fixing screws
(hexagon M5 screws)
Temporally fitting at 2 places
(Tightening about 10mm)
Decoration panel
14 Multi Type Air Conditioner
) on the screws fixed in step above, and slide the panel so
Piping side
Decoration panel fixing screws
(Hexagon M5 screw)
Inlet Grille
Inlet Grille
Inlet Grille
Before installing the decoration panel,
always remove the paper template.
Control box cover
Louver motor
Display
Lead wire for
louver motor and
display