Installation
Installation of Decoration Panel
The decoration panel has its installation
direction.
1. Open the air outlet vane, and extract side covers.
2. Remove the air inlet grille from the decoration panel.
3. Hook decoration panel to indoor unit, using hooks attached at the backside of both side of decoration panel.
4. Arrange wires not to get caught between decoration panel and indoor unit.
5. Screw 7 fixing screws. (9, 12 kBtu/h : 6 screws)
6. Connect the vane motor connector and display connector. (Plasma connector for plasma model)
7. Install the air inlet grille (including the air filter) and side covers.
Air conditioner unit
Plasma filter
(applied only to plasma model)
[Panel type]
Decorative panel
Air outlet vane
[Grille type]
Decorative panel
Air outlet vane
!
CAUTION
Install certainly the
decoration panel.
Cool air leakage
causes sweating.
⇨ Waterdrops fall.
8 Indoor Unit
Control box cover
Mesh
Good example
Decorative panel
Fit the insulator (this part) and
be careful for cool air leakage
Before installing the decoration panel,
always remove the paper template.
Decorative panel
fixing screws
(hexagon M6 screws)
(tightening about 20 mm)
Air inlet panel
Bad example
Air conditioner
unit
Cool air leakage
(no good)
Ceiling
board
Side cover
Side cover
Decorative panel
fixing screws
(hexagon M6 screws)
(tightening about 20 mm)
Air inlet grille
Air conditioner
unit
Ceiling
board
Decorative panel