Troubleshooting - Greenlee EK22GL Instruction Manual

Troubleshooting

Before You Begin
1. Make sure that the battery is charged. Recheck the
battery after several minutes to make sure the
battery is holding its charge.
Problem
Tool is inoperative.
Dies stop during operation
Battery load display flashes
constantly.
Tool loses oil.
Greenlee / A Textron Company
EK22GL Battery-powered, High-speed Crimping Tool
Probable Cause
Dirt, contaminants, etc., in ram area
of tool.
Crimping tool battery contacts
damaged.
Tool components worn or damaged.
Oil level is low.
Air in hydraulic system.
Battery charge low.
Damaged internal seal.
Oil plug not installed properly.
2. Use a nonflammable contact cleaner or pencil
eraser to clean the electrical contacts on the battery
and crimping tool.
3. Reinstall the battery and check the tool again.
Clean tool.
Reform contacts.
Return tool to an authorized
Greenlee service center.
Check oil level. Refill reservoir.
Pull trigger and hold retract button
simultaneously. Hold for approximately
10 seconds.
Charge or replace battery.
Return tool to an authorized
Greenlee service center.
Refill reservoir and replace plug.
10
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Probable Remedy