Panasonic PV-D301 Service Manual page 93

Power off the camcorder first. Then, disconnect the TP Board, and
power on the camcorder. Then, press the STOP button over 5
seconds.
CAUTION:
1. Do not connect or disconnect any cables while the camcorder is
powered on.
2. Before using the TP Board, be sure to clean S301 pattern with
alcohol and confirm that there is no dust in the TP Clip.
3. To achieve the best adjustment results, warm up the camcorder
for approx. 30 minutes before adjustment.
4. When removing the TP Clip from S301 on the camcorder, be sure
to pinch the grips.
6. Set up the camcorder for adjustment as follows:
Note for Method 1 :
1. Connect the 49 mm Ring to the Infinity Lens. Then, insert it into
the Light Box.
2. Set the camcorder so that the Lens Hood of the camcorder
attaches straight and firmly against the 49 mm Ring.
When performing this operation, ensure that there is no gap
between the Lens Hood and the 49 mm Ring and that no external
light can enter.
93