Panasonic PV-D301 Service Manual page 26

and then press "Enter" key.
3. Select "1. Save all data of EEPROM" in Read (Save)/Write All
EEPROM datas menu, and then press "Enter" key.
4. Input the File name, and then press "Enter" key. The data of
EEPROM IC will be stored to your PC.
How to write the EEPROM data which was stored in your PC to EEPROM IC
When it becomes impossible to adjust during service and adjustment, write the EEPROM data
which was stored in your PC to EEPROM IC as follows. And readjust the camcorder.
1. Start up the PC-EVR Adjustment Program.
2. Select "1. Read (Save)/Write AII EEPROM datas." in Main menu,
and then press "Enter" key.
3. Select "2. Data write using stored file" in Read (Save)/Write All
EEPROM datas menu, and then press "Enter" key.
4. Input the saved file name, and then press "Enter" key. The data
will be written in EEPROM IC.
How to initialize the EEPROM IC
When the EEPROM IC (IC306) or Main C.B.A. is replaced, be sure to write the initial data to
EEPROM IC. And adjust the camcorder.
1. Start up the PC-EVR Adjustment Program.
2. Select "1. Read (Save)/Write AII EEPROM datas." in Main menu,
and then press "Enter" key.
3. Select "3. Data write with initial data" in Read (Save)/Write AII
EEPROM datas menu, and then press "Enter" key. And press
"Enter" key once again. The initial data will be written in EEPROM
IC.
6.1.10. HOW TO ACCESS THE MANUAL TRACKING CONTROL
6.1.11. REPLACEMENT PROCEDURE FOR LEADLESS (CHIP) COMPONENT
The following procedures are recommended for the replacement of the leadless components
used in this Unit.
1. Preparation for replacement
A. Soldering Iron
Use a pencil-type soldering iron using less than 30 watts.
B. Solder
26