Greenlee GATOR CK1240 Instruction Manual page 5

IMPORTANT SAFETY INFORMATION
Inspect tool before use. Replace any worn or
damaged parts with Greenlee replacement parts.
A damaged or improperly assembled tool can break
and strike nearby personnel.
Failure to observe this warning could result in severe
injury or death.
Extension cords:
• Use only 16, 14, or 12 AWG
extension cords.
• Do not use extension cords that
are longer than 30 m (100').
• Repair or replace damaged
extension cords.
Failure to observe these warnings
could result in severe injury or death.
Greenlee / A Textron Company
CK1240 and CK1240C Crimping Tools
• Do not operate the tool without dies. Damage to
the ram or crimping tool head can result.
• This tool is not designed for continuous use.
After 30 to 40 crimping cycles, allow the crimping
tool to cool for 15 minutes.
• Do not place the tool in a vise. The crimping tool
is designed for hand-held operation.
• Ensure that all bystanders are away from the
work area when operating the tool.
• Ensure that the work area is clean, dry,
uncluttered, and well-lit.
• Use this tool for the manufacturer's intended
purpose only.
Failure to observe these precautions may result in
injury or property damage.
Do not perform any service or maintenance other
than as described in this manual. Injury or damage
to the tool may result.
Failure to observe this precaution may result in
injury and property damage.
Note: Keep all decals clean and legible, and replace
when necessary.
5
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070