Table of Contents
Advertisement
Troubleshooting
Problem
Tool is inoperative.
Dies stop during operation.
Tool loses oil.
Greenlee / A Textron Company
CK1230 and CK1230C Crimping Tools
Probable Cause
Dirt, contaminants, etc., in ram area
of tool.
Tool components worn or damaged.
Oil level is low.
Air in hydraulic system.
Damaged internal seal.
Oil plug not installed properly.
10
Probable Remedy
Clean tool.
Return tool to an authorized
Greenlee service center.
Check oil level. Refill reservoir.
Pull trigger and hold retract button
simultaneously. Hold for approximately
10 seconds.
Return tool to an authorized
Greenlee service center.
Refill reservoir and replace plug.
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Advertisement
Table of Contents
