Table of Contents
Advertisement
On Screen Display(OSD) Selection and Adjustment
Main menu
SETUP
SETUP
MENU : Exit
: Adjust
: Adjust
SET
: Select another
sub-menu
If this does not improve the screen image, restore the factory default settings.
If necessary, perform the white balance function again. This function will be enabled only
when the input signal is a D-sub or LAN input signal.
Sub menu
To choose the language in which the
LANGUAGE
control names are displayed.
OSD
To adjust position of the OSD window on
POSITION
the screen.
WHITE
If the output of the video card is different from
BALANCE
the required specifications, the color level may
deteriorate due to video signal distortion. Using
this function, the signal level is adjusted to fit
into the standard output level of the video card
in order to provide the optimal image.
Activate this function when white and black
colors are present in the screen.
Use this function to set the power indicator on
POWER
INDICATOR
the front side of the monitor to ON or OFF.
If you set OFF, it will go off.
If you set ON at any time, the power indicator
will automatically be turned on.
Use this function to select the image size of the
4:3 IN WIDE
screen.
WIDE
• WIDE : Switch to full screen mode according to
• 4 : 3 : Change the image signal ratio into 4:3.
ON setting, the monitor power ON button, type
ENABLE LAN
the LAN is driven by the state.
OFF setting, the monitor power switch to ON,
the state does not enter the LAN, and general
monitoring state.
* OFF settings in SOURCE button to
automatically enter the status of LAN that is
running.
Restore all factory default settings except
FACTORY
"LANGUAGE" .
RESET
Press the
18 18
Description
4:3
input image signal.
,
buttons to reset immediately.
Advertisement
Table of Contents
