2-11 Sata Connections; Sata 3.0 Connections - Supermicro X10DDW-i User Manual

2-11 SATA Connections

SATA 3.0 Connections

Ten SATA connections are located on the motherboard.
I-SATA0-3, I-SATA4 and I-SATA5 are supported by
Intel PCH. S-SATA connections 0-3 are supported by
Intel SCU. Please also note that I-SATA4/5, colored in
yellow, are used with Supermicro SuperDOM (Disk-
on-Module) connectors with power-pins built in. Su-
perDOMs are backward-compatible with regular SATA
HDDs and SATA DOMs. These SATA ports provide
serial-link connections, which are faster than the con-
nections of Parallel ATA. See the table on the right for
pin definitions.
Note 1: For SAS 3.0 support, be sure to install the Mezzanine card on Slot
JMEZ1 on the motherboard. Refer to Section 2-6 for more information.
Note 2: For more information on SATA HostRAID configuration, please
refer to the Intel SATA HostRAID User's Guide posted on our website @
http://www.supermicro.com.
SP1 P1_NVME0 P1_NVME1
1
CLOSE 1st
CPU1
FAN8
FAN6
BT1
JSXB1_2
BMC
BIOS
LICENSE
OPEN 1st
2-41
Pin#
1
2
3
4
5
6
7
LAN2 USB0/1(2.0)
LAN1 USB4/5(3.0)
VGA
I-SGPIO2
JOH1
IPMI_LAN
JWD1
A
B
LAN
BIOS
C
JBT1
PCH
D
X10DDW-i
Rev. 1.10
CLOSE 1st
CPU2
OPEN 1st
Chapter 2: Installation
SATA Connectors
Pin Definitions
Signal
Ground
SATA_TXP
SATA_TXN
Ground
SATA_RXN
SATA_RXP
Ground
COM1
A. I-SATA0-3
JSTBY1
B. S-SATA0-3
C. I-SATA4
D. I-SATA5
LE2
JF1