Viking RLPKR2 Instructions Manual

RLPKR2 LP Conversion Kit Instructions for RVGR3302/RVDR3302 Ranges
W A R N I N G
The conversion must be performed by a qualified
installer or gas supplier in accordance with the
manufacturer's instructions and all codes and
requirements of the authority having jurisdiction. Failure to
follow ALL instructions could result in serious injury or
property damage. The qualified agency performing this
work assumes responsibility for this conversion.
The pressure regulator and the burner orifices are set for Natural
gas. To use Liquid Propane gas, the regulator and burner orifices
must be converted.
To convert the range to LP gas, follow these instructions:
1. Disconnect all electrical power at the main circuit breaker or
fuse box.
2. Shut off the gas supply to the range by closing the manual
shut-off valve.
Converting the Pressure Regulator
1. Locate the pressure regulator which can be found on the back
of the range on the right hand side if facing the back of the
range.
2. Unscrew the hex nut cap from the top of the regulator.
3. Unsnap the plastic plunger from the hex nut.
4. Reverse the plunger and reinstall onto the hex nut by
pressing firmly.
Note: Plunger is marked "Nat" and "LP". Converted fuel type will
be shown on the lower portion of the plunger.
Apply sideways finger pressure
to remove pin from cap.
N AT
LP
NAT
LP
conversion
LP
conversion
N AT
Converting the Surface Burners
1. Remove the top grates, burner caps, and burner heads.
Burner
grate
Burner
cap
Burner
head
Burner
base
2. Using a 9/32" or 7 mm nut driver remove the top burner
orifices. These may be accessed through the opening in the
burner base.
Note: Save these orifices for future conversion back to Natural gas,
if required.
3. Locate the proper LP surface
burner orifices included with
the kit according to the chart
below. The orifice stamp can
be either the metric diameter
size or the orfice drill size.
4. Install the orifices in their correct location. To prevent leakage,
make sure the orifice spuds are securely screwed into the
burner base.
Part Number
057741-901
057741-902
057741-903
057741-905
057741-904
035282-000
035283-000
1-EN
Orifice
spud
Orifice
Diameter
Burner BTU Rate
mm
1.19
Left front (A) 16,000
Left rear (B) 6,500 0.71
Center (C) 8,000 0.85
Right rear (D) 11,000 0.95
Right front (E) 15,000 1.15
Bake 30,000 1.68
Broil 14,500 1.03
B C D
A E
Orifice
stamp
Orifice
Stamp
119
71
85
95
115
1.68
1.03