Configuration Guide; Configuring Ht-386 Through Voice Prompt; Dhcp Mode; Static Ip Mode - Grandstream Networks HT-386 User Manual

C
ONFIGURATION
C HT–386
ONFIGURING
DHCP M
ODE
Follow Table 3 with voice menu option 01 to enable HT-386 to use DHCP.
S IP M
TATIC ODE
Follow Table 3 with voice menu option 01 to enable HT-386 to use STATIC IP mode, then use option 02,
03, 04 to set up HT-386's IP, Subnet Mask, Gateway respectively.
TFTP S A
ERVER DDRESS
Follow Table 3 with voice menu option 06 to configure the IP address of the TFTP server.
F S IP A
IRMWARE ERVER
Select voice menu option 13 to configure the IP address of the firmware server.
C S
ONFIGURATION ERVER
Select voice menu option 14 to configure the IP address of the configuration server.
U P
PGRADE ROTOCOL
Select voice menu option 15 to choose firmware and configuration upgrade protocol. User can choose
between TFTP and HTTP.
F U M
IRMWARE PGRADE
Select voice menu option 17 to choose firmware upgrade mode among the following three options:
1) always check, 2) check when pre/suffix changes, and 3) never upgrade
Grandstream Networks, Inc.
G
UIDE
V
THROUGH OICE
DDRESS
IP A
DDRESS
ODE
HT-386 User Manual
P
ROMPT
Firmware 1.0.3.64
Page 17 of 34
Last Updated: 2/2007