Care And Maintenance; Troubleshooting - Jensen JWM9ABK Installation And Operation Manual

CARE AND MAINTENANCE


Keep the product dry. If it does get wet, wipe it dry immediately. Liquids might contain
minerals that can corrode the electronic circuits.

Keep the product away from dust and dirt, which can cause premature wear of parts.

Handle the product gently and carefully. Dropping it can damage circuit boards and cases,
and can cause the product to work improperly.

Wipe the product with a dampened cloth occasionally to keep it looking new. Do not use
harsh chemicals, cleaning solvents, or strong detergents to clean the product.

Use and store the product only in normal temperature environments. High temperature
can shorten the life of electronic devices, damage batteries, and distort or melt plastic
parts.
Ignition
The most common source of noise in reception is the ignition system. This is a result of the radio
being placed close to the ignition system (engine). This type of noise can be easily detected
because it will vary in intensity of pitch with the speed of the engine.
Usually, the ignition noise can be suppressed considerably by using a radio suppression type
high voltage ignition wire and suppressor resistor in the ignition system. (Most vessels employ
this wire and resistor but it may be necessary to check them for correct operation.) Another
method of suppression is the use of additional noise suppressors. These can be obtained from
most CB/A radio or electronic supply shops.
Interference
Radio reception in a moving environment is very different from reception in a stationary
environment (home). It is very important to understand the difference.
AM reception will deteriorate when passing under a bridge or when passing under high voltage
lines. Although AM is subject to environmental noise, it has the ability to receive at great
distance. This is because broadcasting signals follow the curvature of the earth and are
reflected back by the upper atmosphere.

TROUBLESHOOTING

Symptom Solution
Radio will not turn ON or No Try the reset button.
front panel operation Check fuse.
Check 12V+ on accessory wire to radio (RED wire).
Check Ground.
Radio turns ON, but no Verify Volume, Fader/Balance, Mute controls are set correctly (see
owner's manual).
sound
Try the reset button.
Verify proper speaker selection.
Verify proper speaker connections.
Check for shorts or open circuits on speaker wires.
• If short on "A" channel, "B & C" channels will continue to function.
• If short on "B and/or C" channels, "A" channel will continue to function.
CD/DVD does not load fully Make sure unit has power and no other CD/DVD is currently inside.
Make sure transport screw has been removed from rear of unit. Disc will
load for several seconds and then eject if transport screw has not been
removed.
CD/DVD does not play Check to make sure disc is inserted correctly.
correctly
Verify disc is free from dirt, scratches, etc.
Check with factory CDs.
Inspect radio's chassis to verify shipping screw(s) have been removed.
Check factory original CDs for compatibility warnings (due to various
copy-protection, multimedia content, etc.).
No AM or FM reception Verify you are tuned to a valid station.
Check your antenna connection on rear of stereo.
Try a different antenna
DVD plays sound but no Make sure the HDMI cable is routed from the HDMI output to the input on
video the television.
Unit does not respond to Verify that you have a clear line of sight for the IR signal.
Remote Control
Check the batteries.
Confirm the remote IR sensor in plugged into IR input (if applicable).
21
JWM9A