Table of Contents
Advertisement
Front & Rear Panel Descriptions –
1. Power Connector & Switch
Connect the supplied AC power cord
to this IEC jack. The power switch turns the mixer on and off.
2. 48V Phantom Power Switch
simultaneously.
3. XLR Inputs
Connect a balanced mic or line-level signal using
an XLR connector.
4. Alt 3-4 Out
1/4" outputs of all channels that have the Mute/Alt
3-4 switch engaged.
5. Line Inputs
Connect a balanced or unbalanced line-level signal
using a 1/4" connector.
6. Insert
Connect a serial effects processor, such as a compressor
or gate, using a 1/4" Y cable.
7. Aux
Adjusts the level sent from the channel Aux to the Aux send.
8. Gain
Adjusts the input sensitivity.
9. Low Cut Switch
Cuts bass frequencies below 75 Hz at a slope
of 18 dB per octave.
10. Equalization
Boost or cut the level at certain frequencies
to enhance the sound.
11. Pan
Adjusts how much of the signal is sent to the left
and right outputs.
12. Mute / ALT 3-4 Switch
Mutes the channel's signal to the main
mix and sends it to the ALT 3-4 Out when switch is engaged.
13. Channel Fader
Adjusts the level to the main mix.
14. PFL Solo Switch
Allows you to listen to individual channels
singly or in combination with other soloed signals. The rude
solo LED flashes when solo switches are engaged.
15. Pan Assign Switch
Engage the switch to fully pan channel 1 to
the left and channel 2 to the right.
16. Main Out L/R
Connect to the inputs of amplifiers, powered
speakers, or a serial effects processor.
17. Main Mix
Adjusts the level of the signal sent to the main
and tape outputs.
18. Phones
Connect stereo headphones here.
19. CR Out L/R
Feed the inputs of a control room amplifier,
studio monitors or a headphone distribution amplifier.
20. Phones
Controls the headphone output level.
21. CR/Sub MIx
Adjusts the control room and submix output level.
22. Line/Hi-Z Switch
Engage the switch to play a guitar through
channel 1 without using a DI Box.
23. Control Room Source
Determines the source of the control room
outputs.
24. Tape Inputs / Outputs
RCA inputs allow you to connect a line-
level source. RCA outputs allow you to record the main stereo mix.
25. Tape Level
Controls the input level of a source connected
to the tape inputs.
Provides 48V, affecting all XLR jacks
EN ES FR DE
26. Aux Master Control
Controls the level being sent from the Aux
sends.
27. Aux Send
1/4" outputs fed from the Aux Master controls.
28. Return Master Controls
Master level controls for the Stereo
Returns signal paths.
29. St/ Return Inputs
Connect the stereo processed outputs
of an effects processor to these 1/4" TRS jacks.
30. Main Meters
Used to gauge the soloed input or output levels
to ensure that the signals are not clipping.
Quick Start Guide
9
Advertisement
Table of Contents
