Panasonic PT-EW640 Operating Instructions (Functional Manual) page 46

Chapter 3 Basic Operations — Switching on/off the projector
Initial setting (display language)
Select the language to show on the screen.
After completed the initial setting, you can change the display language from the [DISPLAY LANGUAGE] menu.
Press as to select the display language.
1)
2) Press the <ENTER> button to proceed to the initial setting.
Initial setting (installation setting)
Set [PROJECTION METHOD] depending on the installation mode. Refer to "Installation mode" (x page 30) for details.
After completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu → [PROJECTION METHOD].
Press qw to switch the setting.
1)
2) Press the <ENTER> button to proceed to the initial setting.
Initial setting (standby mode)
Set the operation mode during standby. The default setting is [ECO] that keeps power consumption low during standby. When the network
function is used during standby, set to [NORMAL]. After completed the initial setting, you can change the setting from the [PROJECTOR
SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE].
Press qw to switch the setting.
1)
2) Press the <ENTER> button to proceed to the initial setting.
46 - ENGLISH
INITIAL SETTING
Please select DISPLAY LANGUAGE.
SELECT
SET
ENTER
INITIAL SETTING
PROJECTION METHOD FRONT/FLOOR
Change the projection method if the screen display is
upside down or inverted.
CHANGE
SET
ENTER
INITIAL SETTING
STANDBY MODE ECO
If STANDBY MODE is set to ECO, you cannot use
network functions when the projector is standing by.
Also, you cannot use some RS-232C protocol
commands.
CHANGE
SET
ENTER
1/4
2/4
3/4