Table of Contents
Advertisement
Prepare the Hood
1 ] If present, remove all protective polyfilm from the hood and/or parts.
2 ] If present, remove 7" Round Duct Plate from top/back of hood (see illustration below). Keep
3 ] Using the finger cup, remove the grease filters from the hood by pushing down
4 ] Using a 11/32" nutdriver or socket, remove the lock nut retaining the flange of the right cover
10
the screws for further use (screws are on all models).
2 SCREWS
filters out
.
plate (shaded part on illustration below) to the inner back of hood (see inset). Remove the
right cover plate retaining screws (7 screws), then set the blower cover along with its screws
and nut aside.
B
C
5
4
6
1
7
BACK OF HOOD
LOCK NUT
7" ROUND
DUCT
PLATE
and tilting
3
2
Advertisement
Table of Contents
