Table of Contents
Advertisement
5 ] Remove the parts bag, taped on the inner back of hood, near the left corner. Remove the EZ1
brackets from inside the hood by cutting off the tie wrap. Discard the tie-wrap
PARTS BAG LOCATION
6 ] Remove Electrical Power Cable Knockout from top (vertical exhaust) or back (horizontal exhaust)
of hood. For knockout removed from back of hood, install an appropriate strain relief, 1/2" diameter
(not included). For knockout removed from top of hood, the strain relief will be installed later.
ELECTRICAL
POWER CABLE
KNOCKOUT
NON-DUCTED INSTALLATION ONLY
7 ] Remove 3 screws retaining the recirculation cover plate to the hood. Discard this plate
with its screws. Peel off and discard the membrane covering the recirculation grille,
ensuring the openings are totally cleared.
SCREWS
RECIRCULATION
COVER PLATE
EZ1 BRACKETS
11
Advertisement
Table of Contents
