Hardware Setup - IOGear GCS1934 User Manual

Hardware Setup

Hardware Installation
Please make sure that all devices including the GCS1932/1934, DisplayPort monitor, and
computers are powered OFF.
1. Connect the USB keyboard and the USB mouse to the GCS1932/1934 Console ports
located on the rear side panel.
2. Connect the DisplayPort monitor to the GCS1932/1934 Console DisplayPort port located
on the rear side panel. Then, turn DisplayPort monitor on.
3. Connect the main microphone and speakers into the GCS1932/1934 microphone and
speaker jacks located on the front side panel. The microphone and speakers connected
into this front port have priority over those connected on the rear port of GCS1932/1934.
4. Connect the secondary microphone and speakers into the GCS1932/1934 Console
microphone and speaker jacks located on the rear panel.
5. Using the provided cables from IOGEAR,
a. Connect the provided DisplayPort connector into DisplayPort ports
in the KVM Port section of the GCS1932/1934.
b. Connect the provided USB, microphone, and speaker connector into their
corresponding USB, microphone, and speaker ports on the GCS1932/1934.
c. Connect the other end of the KVM cables into their respective DisplayPort,
USB, microphone, and speaker ports on the computers.
6. Connect up to two USB peripherals into the USB type A ports in the USB 3.1 Gen1 hub
section (front and rear panel of the GCS1932/1934).
7. Connect the provided power adapter to an AC power source. Then, connect the power
adapter cable into the GCS1932/1934 power jack.
8. Turn all connected computers power to ON.
Note:
Verify that all the connectors are on the same KVM Port sockets (all in Port 1, all in Port 2,
etc.) and that each socket is marked with an appropriate icon to indicate itself.
10