Kyocera AD-63 Service Manual page 434

• Removing the paper feed pulley
7. Remove the two stop rings.
8. Pull the paper feed shaft toward the rear of
the primary paper feed unit (in the direction of
the arrow) and remove the paper feed pulley
and gear.
• Removing the separation pulley
9. Remove the stop ring from the rear of the
primary paper feed unit.
10. Pull the separation shaft toward the rear of
the machine (in the direction of the arrow)
and remove the separation pulley.
11. Replace the forwarding, paper feed and
separation pulleys.
12. Refit all removed parts.
Cautions:
• When fitting the forwarding pulley, orient it
correctly as shown in Figure 1-4-6.
• When fitting the paper feed pulley and gear, keep
the blue end of the paper feed pulley and the
black end of the gear toward the machine rear.
Paper feed shaft Gear
Figure 1-4-4 Detaching the paper feed pulley
Stop ring Separation shaft Separation pulley
Figure 1-4-5 Detaching the separation pulley
Machine front
Forwarding pulley
Figure 1-4-6
Stop rings
Paper feed pulley
Machine rear
1-4-3
3CC