Table of Contents
Advertisement
STEP 4 (See Diagram 4)
A.) Attach the 110" Lower Cable (#43) to the open Pulley bracket on Lower Pulley Frame
(#11). Secure it with one M10 x 1 ¾" Allen Bolt (#52), two Ø ¾" Washers (#55), and one
M10 Aircraft Nut (#57).
B.) Draw the Cable around the Pulley and then upward to the Double Floating Pulley Bracket
(#21) installed in Step-3. Attach a Pulley to the selected lower holes on the Brackets.
Secure it with one M10 x 2" Allen Bolt (#51), two Ø ¾" Washers (#55), two Cable Retainers
(#36), two cable Retainer Bushings (#37),and one M10 Aircraft Nut (#57).
C.) Draw the Cable around the Pulley then downward to the open slot on Lower Pulley Frame.
Secure the end of Cable to the slot with one M10 x 2 ¾" Allen Bolt (#49), two Ø ¾"
Washers (#55), and one M10 Aircraft Nut (#57).
D.) To adjust the tension of the Cable system by moving the lower Pulley position on Double
Floating Pulley Brackets. Move up the Pulley to increase the tension, move down the
Pulley to loosen the tension.
©IMPEX INC.
13
www.marcypro.com
Advertisement
Table of Contents
