Table of Contents
Advertisement
5) ATX_12V (+12V Power Connector)
1 3
GND
GND
2
4
6) ATX (ATX Power)
+12V
5V SB (Stand by +5V)
Power Good
GND
VCC
GND
VCC
GND
3.3V
3.3V
7) FDD (Floppy Connector)
+12V
+12V
20
VCC
VCC
-5V
GND
GND
GND
PS-ON(Soft On/Off)
GND
-12V
3.3V
1
1
- 19 -
This connector (ATX_12V) supplies the CPU
operation voltage (Vcore).
If this " ATX_12V connector" is not
connected, system cannot boot.
AC power cord should only be connected to
your power supply unit after ATX power cable
and other related devices are firmly connected
to the mainboard.
Please connect the floppy drive ribbon cables
to FDD. It supports 360K,1.2M, 720K, 1.44M
and 2.88M bytes floppy disk types.
The red stripe of the ribbon cable must be the
same side with the Pin1.
Hardware Installation Process
Advertisement
Table of Contents
