❹ Attaching The Optional Cable Cover (Np08Cv); Attaching The Cable Cover - Dukane ImagePro 6650HDSS User Manual

❹ Attaching the Optional Cable Cover (NP08CV)
After finishing connections, attach the supplied cable cover to properly hide the cables.
CAUTION:
• Be sure to tighten the screws after attaching the cable cover. Failure to do so may cause the cable cover to come
off and fall, resulting in injury or damage to the cable cover.
• Do not put bundled cables in the cable cover. Doing so may damage the power cord, resulting in a fire.
• Do not hold the cable cover while moving the projector or do not apply excessive force to the cable cover. Doing
so may damage the cable cover, resulting in injury.

Attaching the cable cover

Tool needed:
• Phillips screwdriver (plus-head) about 9 cm/4 inches in length
9 cm/4 inches
1. Align two claws on the cable cover edge with grooves of
the projector and push the top end.
• The remaining claw on the cable cover also goes in the
projector's groove.
NOTE:
• Be careful not to get cables caught in between the cable cover and
the projector.
2. Tighten the cable cover screws.
• Be sure to tighten the screws.
* As seen from below.
Claw on the cable cover
Groove in back
Cable cover
122
9. Appendix
edge
panel
claw
2
1