Change The Ethernet Port Aggregation Configuration Mode; Reboot The Cable Modem - NETGEAR Nighthawk CM3000 User Manual

Change the Ethernet Port Aggregation
Configuration Mode
To change your cable modem's Ethernet port aggregation configuration mode:
1. Launch a web browser from a computer that is connected to your cable modem.
2. Enter http://192.168.100.1.
A login window opens.
3. Enter the admin user name and password.
The user name is admin. The default password is password. The user name and
password are case-sensitive.
The BASIC Home page displays.
4. Select ADVANCED > Advanced Setup > Ethernet Port Aggregation.
The Ethernet Port Aggregation page displays.
5. Select a configuration mode:
• Disable. This is the default mode. This mode disables the Ethernet port
aggregation function on the cable modem. Do not use the LAN 2 port if you select
this mode.
• Enable (LACP-IEEE 803.3ad). The cable modem communicates with the router
or computer that is connected to the LAN 2 port on your cable modem and checks
to see if Ethernet port aggregation is supported on the router or computer. If
Ethernet port aggregation is supported, the cable modem automatically trunks
the LAN 2 port. If not, the LAN 2 port will not pass traffic.

Reboot the cable modem

Rebooting the cable modem disconnects all network connections to the cable modem's
local area network (LAN). After the cable modem is finished booting and reestablishes
a connection with the Internet, the devices on your network reconnect to the cable
modem's LAN.
To reboot the cable modem:
1. Launch a web browser from a computer that is connected to your cable modem.
2. Enter http://192.168.100.1.
A login window opens.
Manage Your Network
Nighthawk CM3000 2.5 Gbps Cable Modem
19 User Manual