Gigabyte GA-7IXE4 User Manual page 42

SDRAM CAS Latency
This function specify the delay from SCAS[2:0]# to data valid.
2 Cycles Set SDRAM CAS Latency to 2 Cycles.
Set SDRAM CAS Latency to 3 Cycles. (Default value)
3 Cycles
SDRAM TRCD Timing
This function specify the delay from the activation of a bank to the time that a read or write
command is accepted.
1 Cycle Set SDRAM TRCD Timing Value to 1 Cycle.
2 Cycle Set SDRAM TRCD Timing Value to 2 Cycle. (Default value)
3 Cycle Set SDRAM TRCD Timing Value to 3 Cycle.
4 Cycle Set SDRAM TRCD Timing Value to 4 Cycle.
DRAM Integrity Mode
Disabled this function. (Default Value)
Disabled
ECC Set DRAM Integrity Mode to ECC.
Memory Hole
Normal Setting. (Default Value)
Disabled
14MB-15MB Set Address=14~15MB remap to ISA BUS.
15MB-16MB Set Address=15~16MB remap to ISA BUS.
14MB-16MB Set Address=14~16MB remap to ISA BUS.
DRAM Burst Refresh
Disabled Disabled this function.
Enabled DRAM Burst Refresh function. (Default Value)
Enabled
36
BIOS Setup