Cpu Speed Setup - Gigabyte GA-7IXE4 User Manual

7IXE4 Motherboard

CPU Speed Setup

The system bus frequency can be switched at 90MHz, 95MHz, 100MHz, 105MHz, 110MHz and
115MHz by adjusting SW1 (See Figure 1).
The CPU speed must match with the frequency RATIO. It will cause system hanging up if
the frequency RATIO is higher than that of CPU.
SW1: CPU Speed Setup
Note: Please set the CPU host frequency in accordance with your processor's
specifications. We don't recommend you to set the system bus frequency over
the CPU's specification because these specific bus frequencies are not the
standard specifications for CPU, chipset and most of the peripherals. Whether
your system can run under these specific bus frequencies properly will depend
on your hardware configurations, including CPU, Chipsets, SDRAM,
Cards....etc.
AMD CPU Heat Sink Installation:
Beware: Please check that the heat sink is in good contact with the CPU before you turn on your
system.
The poor contact will cause over heat, and might cause damage to your
processor.
90MHz
ON
1
2
3
4
SW1
105MHz 110MHz
ON
1
2
3
4
SW1
Figure 1
7
95MHz 100MHz
ON
1
1
2
2
3
3
4
4
SW1
SW1
115MHz
ON
1 1
2 2
3 3
4 4
SW1 SW1
ON
ON