Gigabyte GA-7DXE User Manual page 82

STEP 6: Load BIOS defaults.
Normally the system redetects all devices after BIOS has been upgraded. Therefore, we highly
recommend reloading the BIOS defaults after BIOS has been upgraded. This important step
resets everything after the flash.
(1) Take out the floppy diskette from floppy drive, and then restart the system. The boot up
screen will indicate your motherboard model and current BIOS version.
American
Megatrends AMIBIOS (C) 1999 American Megatrends
7VTX F4
Check System Health ok,
AMD-Athlon™ Processor-900MHz
Check NVRAM...
262144KB
Wait...
Press F1 to enter Dual BIOS Utility. Press ESC to quit
Press any key to contiune
( C ) American Megatrends Inc.,
63-0001-001199-00101111-071595-VIA_K7-GA7VTX1-F
(2) Don't forget to press <DEL> key to enter BIOS setup again when system is boot up. Use the
arrows to highlight the item "LOAD SETUP DEFAULTS" then press "Enter". System will ask
"Load Setup Defaults (Y/N)?" Press "Y" and "Enter" keys to confirm.
( C ) 1999 American Megatrends, Inc. All Rights Reserved
STANDARD CMOS SETUP
BIOS FEATURES SETUP
CHIPSET FEATURES SETUP
POWER MANAGEMENT SETUP
PNP/PCI CONFIGURATION
LOAD BIOS DEFAULTS
LOAD SETUP DEFAULTS
↑↓→← : Select Item
ESC : Quit
F6 : Load BIOS Defaults
Release:09/16/99
AMIBIOS SIMPLE SETUP UTILITY-VERSION 1.24b
Load Setup Defaults (Y/N) ? N
F7: Load Setup Defaults
Load BIOS Default except Standard CMOS Setup
INTEGRATED PERIPHERALS
HARDWARE MONITOR & MISC SETUP
SUPERVISOR PASSWORD
USER PASSWORD
IDE HDD AUTO DETECTION
SAVE & EXIT SETUP
EXIT WITHOUT SAVING
(Shift) F2 : Change Color
76
Appendix
F5 : Old Values
F10: Save & Exit