Samsung WA12GP User Manual page 11

CHILD-LOCK
6
FUNCTION
/
RINSE BUTTON
7
WASH BUTTON
8
TUB CHECK
9
FUNCTION
/
SOAK BUTTON
10
WATER LEVEL
11
BUTTON
SOUND BUTTON
12-1
(COLD WATER MODEL)
WATER SUPPLY
12-2
BUTTON
(HOT/COLD
WATER MODEL)
AIR TURBO
13
BUTTON
DELAY START
14
BUTTON
15 ECO TUB CLEAN
WA13GPBIC-02962C-01_EN.indd 11
This is a device to protect children from being accidentally hurt while playing
with the washer.
• How to start the Child-Lock function:
- Press the "Power" button to go to an initial washing mode.
- By pressing "Start/Pause" button, you start washing and in case Child
Lock function is needed during the laundry
- Press both the "Rinse" and "Spin" buttons at the same times.(for 3 seconds)
(Note: You cannot perform the function without the "Power" button on.)
• To release the function of Child-Lock: In case the "Child-Lock" is
programmed, press both the "Rinse" and "Spin" buttons at the same time.
Press this button to perform a rinse only or to adjust the rinse count.
You can set the rinse count up to five times.
Press this button to perform a wash only or to adjust the washing time.
You can set the wash time from between 4 to 30 minutes.
If the Tub Check indicator on the display blinks (it blinks for 3 minutes), run
the Tub Clean course.
The Tub Clean function removes dirt from the tub to keep the laundry clean.
Press this button to perform a soak wash.
You can set the soak time from between 20 to 60 minutes.
The water level is automatically adjusted. However, you can select the water
level manually by pressing this button.
If you select the Sound function, all button and washing completed sounds
are muted. (However, even if the Sound Off function is selected, and an error
occurs, the error sound will be heard.)
Whenever you press the Sound button, the setting is toggled in the following
order: Off  On  Off.
Each press of the button cycles through the type of water,
Cold  Cold + Hot  Hot  Cold
Press this button to speed dry your laundry.
This function can only be selected if a spin cycle is set.
Press this button to finish the wash at a specified time.
Turn off your washing machine to cancel a reserved delay start.
You can set the delay start time from between 3 to 19 hours.
Use this program to clean the tub, it will keep the tub clean and sanitary.
The TUB CHECK LED is turned on to notify the user that it is time to clean
the tub.
The powerful spinning force of the washing tub pulsator removes the
contaminations from the exterior of the washing tub to prevent odors or
secondary contamination.
setting up your washer_11
2011-09-15 12:00:06