Step 3: Install Agp Card; Step 4: Install I/O Peripherals Cables; Step 4-1: I/O Back Panel Introduction - Gigabyte 8VM533M-RZ User Manual

Step 3: Install AGP Card

1. Read the relateAGP card's instruction document before install the AGP card into the computer.
2. If your AGP card has "AGP 4X(1.5V) notch" (show below), please make sure your AGP card is AGP
4X(1.5V).
3. Please carefully pull out the small white- drawable bar at the end of the AGP slot when you try to
install/ Uninstall the AGP card. Please align the AGP card to the onboard AGP slot and press firm ly
down on the slot .M ake sure your AGP card is locked by the sm all white- drawable bar.

Step 4: Install I/O Peripherals Cables

Step 4-1: I/O Back Panel Introduction

v
u
w
PS/2 Keyboard and PS/2 Mouse connector
u
This connector supports standard PS/2 keyboard and PS/2 m ouse.
Parallel port (LPT)
v
Device like printer can be connected to Parallel port.
Serial port (COMA)
w
Mouse and modem etc. can be connected to Serial port.
VGA port
x
Monitor can be connected to VGA port.
y/{ USB port
Before you connect your device(s) into USB connector(s), please make sure your device(s)
such as USB keyboard, mouse, scanner, zip, speaker...etc. Have a standard USB interface.
Also m ake sure your OS supports USB controller. If your OS does not support USB controller,
please contact OS vendor for possible patch or driver upgrade. For more information please
contact your OS or device(s) vendors.
"*" For 8VM533M-RZ only.
y
x
- 11 - Hardware Installation Process
z *
|
}
{
~