Save & Exit Setup; Exit Without Saving - Gigabyte 7VT880-RZ User Manual

Type the password, up to eight characters, and press <Enter>. You will be asked to confirm the password.
Type the password again and press <Enter>. You may also press <Esc> to abort the selection and not
enter a password.To disable password, just press <Enter> when you are prompted to enter password.
A message "PASSWORD DISABLED" will appear to confirm the password being disabled. Once the
password is disabled, the system will boot and you can enter Setup freely.
The BIOS Setup program allows you to specify two separate passwords:
SUPERVISOR PASSWORD and a USER PASSWORD. When disabled, anyone may access all BIOS
Setup program function. When enabled, the Supervisor password is required for entering the BIOS
Setup program and having full configuration fields, the User password is required to access only basic
items.
If you select "System" at "Password Check" in Advance BIOS Features Menu, you will be prompted
for the password every time the system is rebooted or any time you try to enter Setup Menu.
If you select "Setup" at "Password Check" in Advance BIOS Features Menu, you will be prompted only
when you try to enter Setup.you try to enter Setup.
Save & Exit Setup
CMOS Setup Utility-Copyright (C) 1984-2004 Award Software
Standard CMOS Features
Advanced BIOS Features
Integrated Peripherals
Power Management Setup
PnP/PCI Configurations
PC Health Status
MB Intelligent Tweaker (M.I.T.)
Esc: Quit
F8: Q-Flash
Type "Y" will quit the Setup Utility and save the user setup value to RTC CMOS.
Type "N" will return to Setup Utility.

Exit Without Saving

CMOS Setup Utility-Copyright (C) 1984-2004 Award Software
Standard CMOS Features
Advanced BIOS Features
Integrated Peripherals
Type "Y" will quit the Setup Utility without saving to RTC CMOS.
Power Management Setup
Type "N" will return to Setup Utility.
PnP/PCI Configurations
PC Health Status
MB Intelligent Tweaker(M.I.T.)
Esc: Quit
F8: Q-Flash
Type "Y" will quit the Setup Utility without saving to RTC CMOS.
Type "N" will return to Setup Utility.
Load Fail-Safe Defaults
Load Optimized Defaults
Set Supervisor Password
Set User Password
Save & Exit Setup
Exit Without Saving
Save to CMOS and EXIT (Y/N)? Y
F10: Save & Exit Setup
Save Data to CMOS
Load Fail-Safe Defaults
Load Optimized Defaults
Set Supervisor Password
Set User Password
Quit Without Saving (Y/N)? N
Save & Exit Setup
Exit Without Saving
F10: Save & Exit Setup
Abandon all Data
- 37 -
: Select Item
: Select Item
BIOS Setup