Table of Contents
Advertisement
Supervisor Password Is / User Password Is
These two fields show that User /Supervisor Passwords are set or
not.
Set
System Password is set.
Clear
System Password is not set.
Set Supervisor Password / Set User Password
Enter this field always shows the message.
While this field is highlighted, press [Enter]. The following message
is shown:
Set Supervisor Password: :
Enter New Password
Confirm New Password
If there is an old password then setup will prompt with the following
window instead and a current password will be required to be
entered at first:
Set Supervisor Password: :
Enter Current Password
Enter New Password
Confirm New Password
User can type password in field of Enter New Password, and re-
enter password in field of Confirm New Password for verification.
[
]
[
]
[
]
[
]
[
]
If verification OK:
Setup Notice
Changes have been saved.
[Continue]
The supervisor password is set complete after user press [Enter].
If verification fails:
Setup Warning
Passwords do not match.
Re-enter password.
[Continue]
The formats of the password are as follows:
Length:
No more than 8 characters.
Characters: Alphanumeric keys only. The shift status, Ctrl, Shift,
Alt, and Capital, are ignored.
Password on boot
If password on boot is required, the password must be set
otherwise it cannot be enabled. Enabled this field to have setup
prompt for the password when the computer boots.
Built-in HDD1 Status
Set
HDD Password is set.
Clear
HDD Password is not set.
Built-in HDD1 Password Select
User Only
For normal user entering HDD password.
User+Master Master password must be set first before
user password can be configured.
W468N Notebook User's Manual
password.
assword.
6
31
Advertisement
Table of Contents
