Table of Contents
Advertisement
Installation Guide for the NETGEAR 54 Mbps Wireless PC Card WG511V2H1
1) Authentication request sent to AP
3) Client connects to network
Client
attempting
to connect
Figure 3-9: 802.11 open system authentication
Shared Key Authentication
The following steps occur when two devices use Shared Key Authentication:
The station sends an authentication request to the access point.
1.
The access point sends challenge text to the station.
2.
The station uses its configured 64-bit or 128-bit default key to encrypt the challenge text, and
3.
sends the encrypted text to the access point.
The access point decrypts the encrypted text using its configured WEP Key that corresponds
4.
to the station's default key. The access point compares the decrypted text with the original
challenge text. If the decrypted text matches the original challenge text, then the access point
and the station share the same WEP Key and the access point authenticates the station.
The station connects to the network.
5.
If the decrypted text does not match the original challenge text (i.e., the access point and station do
not share the same WEP Key), then the access point will refuse to authenticate the station and the
station will be unable to communicate with either the 802.11 network or Ethernet network.
This process is illustrated in below.
B-38
802.11 Authentication
Open System Steps
2) AP authenticates
Access Point (AP)
FVM318
IN TER N ET
W LA N
LO CA L
MODEL
ProSafeWirelessVPN Security Firewall
Cable/DSL
LNK
100
PWR
TEST
ACT
Enable
LNK/ACT
1
2
3
4
5
6
7
8
Cable or
DLS modem
Wireless Networking Basics
Advertisement
Table of Contents
