Siemens iQ300 WK14D321HK Instruction Manual And Installation Instructions page 26

Included with the
appliance
Removing the transport
safety bolts
Positioning and
levelling
Number
5 Covers for openings left after removing the transport bolts.
1
1 24-40 mm dia. hose clamp for connection to a siphon.
1
2
On the back of the washer dryer:
– Water drain hose
– Water supply hose
– Mains cable with plug
– Instruction manual and booklet containing after-sales service
addresses
Moisture may remain in the drum following the final inspection which
every washer-dryer undergoes before leaving the factory.
Unscrew all screws using
the spanner supplied.
Insert the protective
covers.
– Appliance stability is essential to ensure that the washer dryer does not
"creep" during spin cycles.
– The installation area must be firm, clean and level.
– Parquet floors and soft floor coverings, e.g. carpets or foam-backed
floor coverings, are unsuitable.
Description
Spanner
Door template
Door hinges with screws
Remove all transport safety bolts completely
and take the mains cable out of the retainers.
– Before using the appliance for the first
time, ensure that all transport safety bolts
have been removed and kept safe for any
subsequent transport.
– If you need to transport the appliance at a
later date, always refit the transport safety
bolts to prevent damage to the washer-
dryer.
26