Other Programming; Registering A Unit - Panasonic KX-TGD512 Operating Instructions Manual

Programming
R If you have set the alarm, the alarm sounds
even if the silent mode is turned on.
Turning silent mode on/off
1
MMENUN#238
2
MbN: Select the desired setting. a
MSAVEN
R If you select "Off", press MOFFN to
exit.
3
Enter the desired hour and minute you
wish to start this feature.
4
*: Select "AM" or "PM". a MOKN
5
Enter the desired hour and minute you
wish to end this feature.
6
*: Select "AM" or "PM".
7
MSAVEN a MOFFN
Changing the start and end time
1
MMENUN#237
2
Continue from step 3, "Turning silent
mode on/off", page 30.
Selecting groups to bypass silent
mode
1
MMENUN#241
2
MbN: Select the desired groups. a
MSELECTN
R " " is displayed next to the selected
group numbers.
R To cancel the selected group:
MbN: Select the group. a Press
MSELECTN again. "
3
MSAVEN a MOFFN

Other programming

Changing the handset name
The default handset name is "Handset 1" to
"Handset 6". You can customize the name
of each handset ("Bob", "Kitchen", etc.). This is
useful when you make intercom calls between
For assistance, please visit http://shop.panasonic.com/support
30
TGD51x_OI(en)_1007_ver002.pdf 30
handsets. To display the handset name in
standby mode, turn on the handset name
display feature (page 30).
1
MMENUN#104
2
Enter the desired name (10 characters
max.). a MSAVEN a MOFFN
Displaying the handset name
You can select whether or not the handset
name is displayed in standby mode. The
default setting is "Off".
1
MMENUN#105
2
MbN: Select the desired setting. a
MSAVEN a MOFFN

Registering a unit

Operating additional units
Additional handsets
Up to 6 handsets can be registered to the
base unit.
Important:
R See page 5 for information on the available
model.
Registering a handset to the
base unit
The supplied handset and base unit are
pre-registered. If for some reason the handset
" disappears.
is not registered to the base unit, re-register
the handset.
1
Handset:
MMENUN#130
2
Base unit:
Press and hold MLOCATORN for about 5
seconds.
R If all registered handsets start ringing,
3
Handset:
Press MOKN, then wait until a long beep
sounds.
press MLOCATORN again to stop, then
repeat this step.
2016/10/07 10:05:47