Sloped Agc Operation - Yaesu FTdx5000MP Operating Manual

T C
OOLS FOR
In traditional AGC systems, the audio output from the transceiver becomes essentially constant, once the threshold
for AGC action is reached (usually several dozen dB above the no-signal
noise floor). The FT 5000, however, includes an innovative Sloped AGC
DX
system on the VFO-A receiver that allows the audio volume to rise and fall
slightly according to signal strength. Although the rise/fall slope is not dra-
matic, it is sufficient to allow you to use your ear to discern and separate
signals according to signal strength, not just audio frequency.
Using Sloped AGC
1. Press the [ MENU ] button briefly to enter the Menu
mode.
2. Use the ( VFO-A )[ SELECT ] knob to select Menu
item "107 ROUT AGC SLP".
3. Rotate the ( VFO-B )[ SELECT ] knob to change the
setting to "SLOPE".
4. Press and hold in the [ MENU ] button for two sec-
onds to save the new setting and exit to normal op-
eration. You will now be using the Sloped AGC
system.
Page 68
OMFORTABLE AND
AGC A
UTOMATIC

SLOPED AGC Operation

E
FFECTIVE
G C
AIN ONTROL
FT 5000 O
DX
R
ECEPTION
SLOPED
NORMAL
Input Signal
( VFO-A )[ SELECT ] Knob
[ MENU ] Button ( VFO-B )[ SELECT ] Knob
M
PERATING ANUAL