Troubleshooting 2 - Pioneer VSX-1326-K Operating Instructions Manual

13 Additional information

Troubleshooting 2

AVNavigator
Symptom Causes
AVNavigator does not interact The receiver's power is not
well with the receiver. turned on.
The receiver or computer is not
connected to the LAN.
The router's power is off.
AVNavigator's network settings
are not correct.
The receiver's port number set-
ting has been changed.
Network connections could be
restricted due to the computer's
network settings, security set-
tings, etc.
When the operating instructions
interactive mode is changed, the
settings may not be transferred
to the browser, causing AVNavi-
gator to stop interacting.
82
En
Remedy
Turn the receiver's power on. (Wait about
60 seconds after the power turns on for
network functions to start.)
After this, press Detection in AVNavigator
to redetect the receiver.
Connect a LAN cable to the receiver or
computer (page 22).
After this, press Detection in AVNavigator
to redetect the receiver.
Turn the router's power on.
After the router is fully started up, press
Detection in AVNavigator to redetect the
receiver.
If your router does not support DHCP,
the receiver's IP address must be set in
AVNavigator. First set the IP address on
the receiver, then set the same address in
AVNavigator (page 71).
After this, press Detection in AVNavigator
to redetect the receiver.
Click Settings on the AVNavigator's func-
tion menu, select the IP Address tab and
input the changed port number (one of the
port numbers set on the receiver) (page 72).
After this, press Detection in AVNavigator
to redetect the receiver.
Check the computer's network settings,
security settings, etc.
After this, press Detection in AVNavigator
to redetect the receiver.
Either refresh the page's display using the
browser's refresh button or display a differ-
ent page from the links so that the setting
is transferred.
Symptom Causes
When the Wiring Navi, This is because of the browser's
security function.
Interactive Manual, Glossary
or Software Update is
launched, a warning about
security protection appears
on the browser.
AVNavigator cannot be An error message may appear
installed. if there are not enough system
resources available.
Installation of AVNavigator may
fail because of incompatibilities
with other applications.
Software updating does not There may be a problem with
operate well. your Internet Service Provider's
network.
USB interface
Symptoms Causes
The folders/files stored on a
The folders/files are currently
USB memory device are not stored in a region other than the
displayed. FAT (File Allocation Table) region.
The number of levels in a folder is
more than 8.
There are more than 30 000 fold-
ers/files stored in a USB memory
device.
The audio files are copyrighted.
Remedy
This is not a problem. Perform the opera-
tion to authorize the blocked contents.
Re-start the PC, then start the installer
(AVNV_XXX_xxx.exe) with no other applica-
tions active.
Try the following, in the order indicated.
1. If there are any other applications active,
exit the other applications and try starting
the installer (AVNV_XXX_xxx.exe) again.
2. If that does not work, try restarting your
PC, and starting the installer (AVNV_XXX_
xxx.exe) with no other applications active.
Contact your contracted provider.
Remedies
Store the folders/files in the FAT region.
Limit the maximum number of levels in a
folder to 8 (page 31).
Limit the maximum number of folders/files
stored in a USB memory device to 30 000
(page 31).
Copyrighted audio files stored on a USB
memory device cannot be played back
(page 31).