Table of Contents
Advertisement
EN
SUB-TRIM
The Sub-Trim function allows electronic adjustment or centering
of each servo to get the servo arm exactly perpendicular to the
servo, or in the exact optimum desired position. Minor sub-trim
values can be used to correct this offset inaccuracy. Sub-trim is
adjustable for all channels.
CAUTION: Use only small sub-trim values so a servo's
maximum travel is NOT overdriven.
*Reference chart for options available for each channel:
Channel
Steering
Throttle
Aux 1
Aux 2
TIMER
The Timer function supports Up and Down timing. When started
by an assigned button, the time shows on the Main Screen.
Tip: Refer to Switch Screen instructions for assigning
a button to the Timer (Button E on the grip handle is
recommended).
Down timer – is the default timer type. The timer can be set in
10-second increments to count down from 10 minutes. Normally,
this timer is programmed for the length of a race. The timer's
default setting is 5 minutes runtime for electric (battery capacity)
and gas-powered (fuel-tank capacity).
Start the timer by pressing the assigned timer button. When
the time expires, an alarm will sound (when Buzzer is not set to
OFF) and then begin to count up. To pause or continue the Down
timer, press the timer button once. To reset the Down timer to its
pre-programmed value, press and hold the timer button for more
than 3 seconds.
NAME
Assign a name for a model memory in this screen. 10 characters
can be used to name a model. This name shows on the Main
Screen when an model memory is active.
Tip: You can only change a model name when the model
memory is active.
A Active model memory
B Model Name (10 character spaces available)
C Marker showing selected character
12
Description
L (left)
R (right)
B (brake)
F (forward)
H (high)
L (low)
H (high)
L (low)
A
A Channel
B Box shows around selected text
C Value for servo alignment (varies among channels)
* Range is 0 to 100 in both directions
Up timer - is started by pressing the timer button and counts up
from 00:00 seconds, functioning as a stopwatch. The Up timer
is useful for timing a fuel run to determine fuel mileage/pit stop
strategy. The Up timer can also be used for electric vehicles to
time the run time of a battery pack for determining gear ratio and
setup. To pause or restart the Up timer, press the timer button. To
reset the Up timer to 00:00 press and hold the timer button for
more than 3 seconds.
A
A Value for timer
B Box shows around selected text
C Options: Inhibit, Down and Up
A
B
C
Spektrum DX4C • tranSmitter inStruCtion manual
B
C
B
C
Advertisement
Table of Contents
