Table of Contents
Advertisement
TRUE
SPEC SERIES®: STR, STA & STG, ROLL-IN AND ROLL-THROUGH
OPERATION
STARTUP
A. The compressor is ready to operate. Plug in the cooler.
B.
Temperature controls are factory-set to give refrigerators
an approximate temperature of 35°F (1.6°C) and freezers
an approximate temperature of -10°F (-23.3°C). Allow unit
to function several hours, completely cooling cabinet before
changing the control setting.
Temperature Control Location and Settings.
• Temperature control type will vary upon model and age of
cabinet.
• Mechanical control or electronic control without display:
- Inside cabinet
- Behind cabinet
- Behind front or rear access grill
• Electronic control with display:
- In countertop
- In top louvered panel
- In or behind bottom louvered grill
See website for adjustments, sequence of operation, and more
information.
C. Excessive tampering with the control could lead to service
difficulties. Should it ever become necessary to replace
temperature control, be sure it is ordered from your TRUE
dealer or recommended service agent.
D. Good air flow in your TRUE unit is critical. Be careful to
load product so that it neither presses against the back wall,
nor comes within four inches of the evaporator housing.
Refrigerated air off the coil must circulate down the back wall.
NOTE: If the unit is disconnected or shut off, wait five minutes
before starting again.
RECOMMENDATION - Before loading product we recommend
you run your TRUE unit empty for two to three days. This allows
you to be sure electrical wiring and installation are correct and no
shipping damage has occurred. Remember, our factory warranty does
not cover product loss!
LIGHT SWITCH LOCATION:
Light switch location depends upon the model. Most instances the
switch is located next to the temperature control.
ENERGY-SAVER SWITCH
With the "-" mark in the down position, this will indicate that the
ENERGY SAVER FUNCTION is OFF and will activate the door/
frame heaters. With the "0" mark in the down position, this will
indicate that the ENERGY SAVER FUNCTION is ON and will
deactivate the door/frame heaters.
DIGITAL TEMPERATURE DISPLAY
The digital temperature display can view ˚C or ˚F. To achieve this,
there is a small plug that will need to be removed to achieve ˚C
reading. See image 1 for temperature display location. If the plug is
kept in the back of the digital display ˚F will be viewable. See images
for reference. When temperature display is in ˚C mode place the
plug in a safe place so it can be easily reinstalled for ˚F reading.
1
Rear of Rainshield
˚F
2
˚C
3
.
.
www
truemfg
com
8
8
Advertisement
Table of Contents
