Step 8. Check The Ignition Of Surface Burners And Oven Burners - Samsung NX58H5600 Installation Manual

3.
right surface burner grates on the
cooktop. The edges of the grates
should match up with the edges
of the cooktop.
Step 8. Check the ignition of surface burners and oven
burners
Check the operation of all cooktop and oven burners after the range has been
installed and assembled, gas supply lines have been carefully checked for leaks,
and electrical power cord has been plugged in.
All surface and oven burners have electronic ignition.
To turn on a surface burner:
1. Push in and turn the control knob
for that surface burner to the LITE
position. The "clicking" sound
indicates the electronic ignition
system is operating properly. The
burner will light in about 4 seconds,
after the air has been purged from
the supply line.
2. After the burner lights, turn the
control knob to the desired setting.
The "clicking" sound will stop and the flame height will change from Max. to
Min. during turning the control knob.
3. Repeat steps 1 and 2 to check the operation of each surface burner
insuccession.
Place food in the oven after preheating if the recipe calls for it. Preheating is
important for good baking results. After the oven has reached the desired
cooking temperature, it will beep 6 times.
To start the bake burners:
1. Press the Bake pad. The oven will beep every time a pad
is pressed.
The default temperature 350 ° and the Start indicator
will blink on the display. If the default temperature is the
desired cooking temperature, skip to step 2.
2. Press the number pads to change the temperature
setting to the desired temperature setting. The selected
cooking temperature and the Start indicator will blink on
the display.
34_ installation instructions
(Install)NX58H56_DG68-00524A_EN+CFR.indb 34
Place the left, center, and
08/02/2014 11:54:51