Model And Serial Number Location; Cabinet Installation; Important Note - Electrolux E30MC75PPS Installation Instructions Manual

MICROWAVE/ WALL OVEN COMBINATION
If oven is used in a new branch circuit installation
(1996 NEC), mobile home, recreational vehicle,
or where local codes DO NOT permit grounding
through the neutral (white) wire, the appliance
frame MUST NOT be connected to the neutral wire
of the 4-wire electrical system. (see fi gure 3):
1. Disconnect the power supply.
2. Separate the green (or bare copper) and white
appliance cable wires.
3. In the junction box:
Connect appliance and power supply cable wires as
shown in Figure 3.
Cable from Power Supply
Ground Wire
Red
Wires
Ground Wire
(Bare or Green
Wire)
Junction Box
Cable from appliance
Figure 3
4-WIRE GROUNDED JUNCTION BOX

Model and Serial Number Location

The serial plate is located along the interior side trim of
the oven and visible when the door is opened.
When ordering parts for or making inquires about your
oven, always be sure to include the model and serial
numbers and a lot number or letter from the serial plate
on your oven.
Serial Plate
Location
INSTALLATION INSTRUCTIONS
White Wire
Black
Wires
White Wire
U.L.-Listed Conduit
Connector (or CSA
listed)
4

4. Cabinet Installation

IMPORTANT NOTE

Do not lift the oven by the door handle.
Heavy Weight Hazard
• Use 2 or more people to move and install wall oven.
• Failure to follow this instruction can result in injury
or damage to the unit.
1 Unpack the wall oven. Remove the bottom trim
taped on the oven side panel.
2 Remove the lower oven door to reduce the weight
of the appliance and to facilitate its handling and its
installation.
To remove the oven door see following steps:
1. Open the door to the fully opened position (Figure 4).
2. Pull up the lock located on each hinge toward the front
of range. You may have to apply a little upward pressure
on the lock to pull it up (Figure 5).
3. Grasp the door by the sides, pull the bottom of the door
up and toward you to disengage the hinge supports.
Keep pulling the bottom of the door toward you while
rotating the top of the door toward the appliance to
completely disengage the hinge levers (Figure 6).
4. Proceed in reverse to replace the oven door. Make sure
the hinge supports are fully engaged before unlocking
the hinge levers.
NOTE: The oven door is very heavy. Be sure to have a
fi rm grip before lifting the oven door off the hinges. Use
caution once the door is removed. Do not lay door on its
handle. This could cause dents or scratches.
Lock in normal position
Figure 4
Lock engaged for door removal
Figure 5
Figure 6
Hinge Slot - Door removed
from the appliance