Advertisement
4. Select the appropriate cycle and settings
for each load.
NOTE
Over-drying can cause wrinkles, shrinkage,
lint, harshness and a build up of static
electricity.
● Press the power
button turn to on the unit.
● Turn the cycle selector ring (on some mod-
els) in either direction or repeatedly press
the cycles button (on other models) to scroll
to the desired cycle. The indicator for that
cycle will be illuminated. See the "Cycle
Selection" section in this guide for descrip-
tions of each cycle.
● The estimated drying time for Auto Dry
cycles or the actual drying time for Time Dry
cycles will be displayed.
● A suitable drying temperature, dryness level
and options will automatically be indicated
for the cycle selected. See the "Dryer Set-
tings Chart" for more details.
● To change the drying temperature, dry-
ness level, or drying time press the temp,
dry level or dry time buttons to scroll to the
desired settings.
NOTE
If a setting is not available for the cycle
selected, the indicator will not light.
● Adjustments made to cycle settings will be
remembered and recalled each time that
cycle is selected in the future.
NOTE
To prevent unintentional and accidental ex-
posure of delicate material to excess heat or
unexpected steam, the sanitize temperature
setting and the perfect steam
not be remembered and must be reselected
each time.
To return to factory settings,
press power and look for console
light up. wait at least 10 seconds,
then press the dry level and
options buttons at the same time
and hold until the signal sounds.
● To select or deselect an option, press op-
tions; then, while the indicator is blinking,
press set. The indicator will light when the
option has been selected. It will no longer
be lighted when the option has been deleted.
Operating Instructions
5. Start the cycle.
● Close the door and press start. The dryer will
● Select delay start (on select models) to
● To add a forgotten item to the dryer drum,
● To change the settings or options after the
● To change the cycle once the cycle has
● A signal will sound at the end of the cycle if
If drying a single large or bulky item remove
the item part way through the cycle and turn it
"inside out" to maximize drying effectiveness.
Place item back in dryer and re-start cycle.
6. When the cycle ends, remove items imme-
Clean the lint filter after every load. CLEAN
LINT will be displayed at the end of the cycle
to remind you to remove lint from the filter.
option will
TM
not operate with the door open.
delay the beginning of the cycle, if desired.
press pause and open the door. Opening
the door with a cycle running will also pause
the cycle. Add the item, close the door and
press start to resume the cycle.
cycle starts, press pause, make the new
selections and press start again.
begun, press cancel to stop the current
cycle, select a new cycle, and press start
again. Just turning the cycle selector ring or
pressing the cycles button will not change
the cycle.
the chime option has been selected.
NOTE
diately and hang or fold.
IMPORTANT
9
Hide quick links:
Advertisement
