Advertisement
Service Prevention Checklist, continued
Drying cycle takes
Lint filter is clogged with lint.
too long, outside of
the dryer feels too
Exhaust duct requirements have not
hot or smells hot.
been met.
Electric dryer is connected to a 208
volt circuit.
Drying procedures have not been
followed.
Outside exhaust hood or exhaust duct
may be clogged or restricted.
High humidity.
Excess moisture
Exhaust damper stuck open or not
in drum between
present.
cycles
Excessive wrinkling.
Dryer is overloaded.
Items left in dryer too long.
Insufficient sorting of items.
Drying temperature too high.
Scratching or chip-
Foreign objects such as coins, pins,
ping of the drum
clips or buttons are inside the dryer.*
finish.
Permanently attached items such as
belt buckles, zippers and fasteners
may be hitting the inside of the drum.*
*Drum damage caused by foreign objects or permanently attached items is not covered by the
warranty.
Solutions to Common Inquiries
Make sure all lint has been removed from the
dryer lint filter before starting each cycle.
Exhaust duct must be at least 4 inches in di-
ameter and made of rigid or semi-rigid metal.
When in place, the duct must have no more
than four 90° bends and must not exceed length
listed in INSTALLATION INSTRUCTIONS.
Drying time will be 20% longer than drying on
a 240 volt circuit.
See "Operating Instructions."
Clean out any obstruction.
Use a dehumidifier near the dryer.
Fix or clean the damper, or install new one.
Do not overload. See "Operating Instruc-
tions."
Remove items as soon as cycle ends.
See "Operating Instructions."
Follow fabric care label instructions.
Always remove foreign objects from pockets
before laundering. Remove objects from drum
and restart dryer.
It may be necessary to sew a scrap of
material securely around ornaments before
drying to prevent scratching and damage to
the dryer.
23
Hide quick links:
Advertisement
