Table of Contents
Advertisement
Changing the Machine Settings on the LCD
This section describes the procedure to change the settings in the Device settings screen, taking the steps
to specify Extended copy amt. as an example.
Note
• The * (asterisk) on the LCD indicates the current setting.
1.
Make sure that the machine is turned on.
2. Press the Setup button.
The Setup menu screen is displayed.
3. Use the
button to select Device settings, then press the OK button.
When you change the fax settings, press the Setup button, then select Fax settings.
4. Use the
button to select Output settings, then press the OK button.
5. Use the
button to select Extended copy amt., then press the OK button.
6. Use the
button to select a setting item, then press the OK button.
For details on each setting item:
Fax settings
Output settings
LAN settings
Dev. user settings
Firmware update
Reset setting
Note
• You can reduce the operating noise when printing at night.
About Quiet setting
155
Advertisement
Table of Contents
Troubleshooting
