Door Reversal Instructions; Reversing The Door Swing - Crosley CRH10SW User Instruction

DOOR REVERSAL INSTRUCTIONS

Tool required: Philips screwdriver, flat bladed screwdriver, hexagonal spanner.
z
Ensure the unit is unplugged and empty.
z
To take the door off, it is necessary to tilt the unit backwards. You should rest the unit
on something solid, so that it will not slip during the door reversing process.
z
All parts removed must be saved to do the reinstallation of the door.
z
Do not lay the unit flat as this may damage the coolant system.
z It's better that 2 people handle the unit during the assembly.
Only FREEZER DOOR
1. Unscrew the top hinge cover, (Fig. 1)
2. Remove the top hinge cover.
3. Loosen the top hinge screws with Phillips head screwdriver.
4. Adjust the door or put a spacer in between and then tighten the screws.
5. Replace the top hinge cover.
6. Move the hinge hole cover from left side to right side.

REVERSING THE DOOR SWING

Left/right door opening method:
This product allows you to reverse the door opening from left to right and back. You can
select your preference of door opening by following the procedure to make the change.
Dismantling: (see figure 1 and figure 2)
1. Affix refrigerator and freezer door by sticking adhesive tape on both sides to hold
doors in place.
2. As shown in figure 1, dismantle the hinge cover screw on the upper part of freezer
door with a Phillips head screwdriver. Then remove the three screws that hold the hinge.
Take out the hinge by pulling it vertically, and keep it in a safe place.
3. Remove the adhesive tape on freezer door, lift it and take off the door, and carefully
put it aside.
4. Dismantle all screws of the middle hinge, lift it and take off the middle hinge, and keep
all hinge parts in a safe place.