Cleaning Your Refrigerator; Cleaning The Exterior - Westinghouse WSE7000S User Manual

cHANGiNG tHE LiGHt bULb
fREEzER LiGHt StANdARd
1. Switch off the power at the power point and remove
the cord by pulling the plug.
2. Carefully unclip the light cover by pulling the light cover
tab at the rear, towards you.
3. Unscrew the light bulb and replace it with a new bulb
of the same type and wattage. If, when you remove the
light bulb the small rubber "O" ring comes out with the
bulb, fit the "O" ring over the new bulb and screw bulb
into the socket (see diagram at bottom of page).
Never insert your finger into the light bulb socket to
WARNING check for the presence of the "O" ring.
4. Replace the light cover by hooking the light cover lugs
into the front of the housing and pressing the rear of the
cover up until it clips in.
5. Wait 5 minutes to ensure pressures in the refrigeration
system are equalised before turning the refrigerator on
at the power point.
TIPS & INFORMATION
Ensure the 'O' ring is in place before replacing the bulb.
Light bulb "O" ring
fREEzER LiGHt icE & wAtER
1. Switch off power.
2. Remove cover located at the rear under the icemaker.
3. Unscrew 2 bulbs and replace.
4. Replace light cover.
5. Wait 5 minutes and turn power back on.

cLEANiNG YoUR REfRiGERAtoR

cLEANiNG tHE ExtERioR

BEFORE CLEANING: Turn the refrigerator off at the
power point and unplug the cord to prevent any chance
of electrocuting yourself.
An occasional wipe over with a clean, damp cloth will help
remove finger marks. You should only clean the doors with
lukewarm, soapy water and a soft cloth. Rinse with clean
water and then wipe the surface with a soft, clean cloth to
remove any soapy residue.
Note: Only wash plastic parts or decorative trim with warm
(not hot) water using an unscented detergent.
doors – painted
Clean as described above for the cabinet.
doors – Stainless Steel
Your stainless steel appliance is manufactured from a mark
resistant stainless steel. This stainless steel has a special
advanced protective coating that helps ease the removal
of marks such as finger prints or water spots. To keep your
stainless steel refrigerator looking its best, you should clean
it regularly. You should only clean the stainless steel doors
with lukewarm soapy water and a soft cloth. Rinse with
clean water and then wipe the surface with clean water
and a soft, clean cloth to remove any soap residue.
Light socket
Note: It is important to wipe in the direction of the grain of
the stainless steel to avoid any undue marking of the surface.
WARNING
Do not use abrasive pads or other cleaners as they are
likely to scratch the surface. Damage to this product
after installation is not covered by your warranty.
CLEANING
23