Ice & Water Features; Twist Ice & Serve; Ice & Water Dispenser Features; How The Water Dispenser Works - Westinghouse WSE7000S User Manual

CAUTION
Never close the door while the telescopic slides are extended.
It may damage the slide and/or the refrigerator or cause the
slide to become disengaged from the refrigerator.
CAUTION
To clean a crisper cover with telescopic extension slides,
simply wipe with a damp cloth and warm soapy water.
Never immerse the cover in water, as this could affect the
operation of the slide.
icE & wAtER fEAtURES*
twiSt icE & SERVE
To use, remove the tray, fill with water and place back in
the freezer. Once ice has formed (approximately 3 hours)
simply twist the knob at the front clockwise until the ice
drops into the bin below.
icE & wAtER diSpENSER fEAtURES
The ice and water dispenser conveniently dispenses cool,
filtered water and ice cubes or crushed ice. To operate the
ice dispenser, select an ice option using the electronic display.
Press a glass against the dispensing paddle. Hold the top
of the glass as close as possible to the ice outlet, so that
you will catch all the ice. To stop dispensing ice, pull the
glass away from the dispensing paddle. Do not remove the
glass until the ice has finished coming out.
*On selected models
To operate the water dispenser, press a glass against the
dispensing paddle. To stop dispensing water, pull the glass
away from the dispensing paddle. A drip tray located at
the base of the dispenser (see diagram above) will catch
small spills and allow them to evaporate. The drip tray is
removable and dishwasher safe.
CAUTION
Do not pour water or excess cubes into the drip tray
because it is not connected to a drain.
dispenser lamp
The dispenser has a light which can be turned on and off
by pressing the Lamp button on the electronic display (see
diagram below). The lamp is also activated for 6 seconds
whenever a dispensing paddle is pressed. The light comes
from 6 ultra bright LEDs (light emitting diodes), which are
part of the electronic display. These are not customer
replaceable. The same technology is used in the interior
multiflow duct (blue strip lights).

How tHE wAtER diSpENSER woRKS

After the refrigerator is connected to the water supply,
fill the water tank by holding a glass against the dispenser
paddle. You may need to hold the glass against the paddle
for up to 2 minutes before water begins to flow. Continue
to draw water for a further 3 minutes to rid the tank and
plumbing connections of any impurities, the tank will
automatically refill as you dispense water.
CAUTION
Remember, do not drink this water as it may have impurities in it!
TIPS & INFORMATION
The water connection to your ice and water product
should only be done by a licensed refrigeration mechanic,
plumber or electrician.
The water dispenser water tank is located behind the
upper crisper bin in the refrigerator compartment.
USING YOUR
15
APPLIANCE