Installing Your Ice And Water Filter - Westinghouse WSE7000S User Manual

iNStALLiNG YoUR icE ANd wAtER fiLtER

Never install the water filter in an area of direct sunlight.
Check for water leaks at all water connection points in the
first 2 to 3 hours after installation, and correct it in case of
any water leak. Recheck after 24 hours; if leak still occurs, it
is recommended to contact a licensed plumber for advice.
iNStALLAtioN
Water is to be connected as per diagram below.
sink
brackets
mains
water inlet
1/2"
tap fitting
kitchen
cupboard
Step 1
Remove ice cream shelf (in freezer) and ensure that the Ice
maker is switched OFF
ICE MAKER ON OFF SWITCH
OFF ON TEST
FOR SERVICE
USE ONLY.
HOLD DOWN
FOR 15 SECS.
Step 2
Disconnect the refrigerator from the power supply.
Step 3
Connect tap fitting to water supply tap. Tap must be close
to the refrigerator.
Step 4
Install the brackets within 1 metre from the water supply tap,
in a vertical orientation where possible, using the screws
provided.
Do not screw the brackets into the refrigerator as this
may void your warranty and permanently damage
the refrigerator.
Step 5
Write date on filter. The filter will need to be replaced
every 12 months.
Step 6
Extend the red collar and clip a circlip around the collar
at both ends of the filter.
Step 7
Fit filter to brackets with water flow arrow pointing up.
water
flow
direction
INSTALLATION
19