TRACTOR REQUIREMENTS
Tractor Requirements and Capabilities
•
ASAE approved Roll-Over Protective Structure (ROPS) or ROPS cab and seat belt.
•
Tractor Safety Devices ......................... Slow Moving Vehicle (SMV) emblem, lighting, PTO master shield
•
Tractor Horsepower:
-Minimum ...................................15HP - HDTH5, 20HP - HDTH6
-Maximum.......... ........................35HP - HDTH5, 40HP - HDTH6
•
Hitch -Lift Type Mower:
-Lifting Capacity .........................Lift - 650 lbs. - HDTH5
•
Front End Weight................................. As needed to maintain 20% weight on front axle
•
Power Take Off.................................... 540 RPM, 6-spline 1-3/8" diameter output shaft
ROPS & Seat Belt
The tractor must be equipped with a Roll-Over-Protective-Structure (ROPS) (tractor cab or roll-bar) and seat
belt to protect the operator from falling off the tractor, especially during a roll over where the driver could be
crushed and killed. Only operate the tractor with the ROPS in the raised position and seat belt fastened.
Tractor models not equipped with a ROPS and seat belt should have these life saving features installed by an
authorized dealer. OPS-U- 0003
Operate this Equipment only with a Tractor equipped with an approved
roll-over-protective system (ROPS). Always wear seat belts. Death or
serious injury can result from falling off the tractor and/or becoming
pinned or trapped under the tractor or implement particularly during a
rollover accident.
HDTH 5 & 6 Finish Mower 08/21
© 2021 Alamo Group Inc.
OPERATION
.........................Lift - 740 lbs. - HDTH6
Operation Section 4-3