Gateway Solo 9500 User Manual page 243

Reinstalling Windows NT 4.0 video device drivers
Use the instructions in this section to reinstall the drivers that support the
video devices in your computer.
To reinstall the Windows NT 4.0 video device driver:
1
Make sure you ran the Windows NT 4.0 Locator utility to find the video
driver. For more information, see "Locating Windows NT 4.0 drivers" on
page 233.
2
Place Disc 1 of the System Restoration Kit into your CD/DVD drive.
3
If the CD starts automatically, close the CD window.
4
If the driver location information for the video driver ends with a file
name (for example, setup.exe), go to Step 5.
- OR -
If the driver location information for your video card driver ends with
a backslash (\), go to Step 10.
5
Click
Start
6
In the
Open
drive letter of your CD/DVD drive), then type the driver location
(directory path) you found using the procedure in "Locating
Windows NT 4.0 drivers" on page 233.
7
Click
OK
8
Reinstall your video driver by following the on-screen instructions. You
have completed the driver reinstallation.
9
If required, go to "Reinstalling Windows NT 4.0 audio device drivers" on
page 237. Otherwise, go to "Reinstalling the Windows NT 4.0 Service
Pack" on page 244.
10
Click
Start
window opens.
, then select . The Run dialog box opens.
Run
text box, type the drive letter (usually D:\ where D is the
.
, then select
Settings
www.gateway.com
, then . The Control Panel
Control Panel
Reinstalling device drivers
235