Gateway Solo 9550 Software Installation

Installing Windows NT 4.0 on a Solo 9550
This kit includes a CD containing Windows NT 4.0 drivers and system BIOS, APM 2.0 Power
Management 2.74, Card Executive 2.74, and these printed instructions.
Windows NT 4.0 drivers and BIOS
The CD contains the following drivers and BIOS:
Driver/Program
Audio (ESS)
Display (NVIDIA)
Keyboard (Bill P Studios)
Modem (Conexant)
Mouse (Synaptics)
Lan\Network (Intel)
System BIOS

Installation instructions

Complete each of the following steps to install Windows NT 4.0 on a Gateway Solo 9550.
Flashing the system BIOS
To flash the system BIOS:
1
Make a bootable diskette.
2
Copy the system BIOS (example:
3
Boot from the diskette.
4
Run the system BIOS (example:
Turning Plug & Play off
Before installing Windows NT 4.0, verify that the
the BIOS Setup utility is set to
Installing Windows NT 4.0 hardware drivers
To install Windows NT 4.0 and the hardware drivers:
1
Install Windows NT 4.0 (not included in this kit). Do not install the Windows NT Service Pack
at this time.
2
Install the network (Intel) drivers as follows:
Copy the
I
When the driver installation program asks for the driver location, select
I
Version
4.03.00.3063
4.00.1381.1581
6.2.0.0
3.05.18.05
5.5.4
5.40.17.0000
29.03 or later
2903.exe
2903.exe
.
NO
directory from the CD to
\Lan
www.gateway.com
) from the CD to the diskette.
) to flash the BIOS.
option on the
Plug & Play O/S
c:\
menu of
Advanced
.
c:\Lan